How To: Replace A Miner After A Control Board Change

Updated

When a miner's control board is replaced, it can report to Foreman as a new device. Use Replace to move the old miner record's history and linked asset over to the new one, instead of ending up with two records.

Before You Start

  • You need the Edit Miners permission. To add the replacement, you also need Add Miners.
  • If the miner has already left the rack, it should have been pulled with Pull Miner and set to In Repair. See How To: Pull A Miner Out Of Service. If it's still in place, set its state yourself:
    1. On the Miners page, open the miner's Actions menu and choose Settings.
    2. Set State to In Repair, confirm, and save.

State field set to In Repair in the miner's settings

Replace the Miner

  1. When the repaired miner is ready, open the old miner's Actions menu and choose Replace.
  2. Click Skip and Add Manually.
  3. Enter the new miner's details and click Next.
  4. Choose what should happen to the old miner record, then click Replace.

Replace option in the miner's Actions menu

Choosing what to do with the current miner before clicking Replace

What You Should See

The new miner appears on the Miners page with the old record's history and linked asset. Set its state to Deployed once it's back on the rack.

Related Articles

Last verified: November 19, 2026

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Can't find what you're looking for?

Our support team can help with setup, hardware and billing questions.

Contact Support