vho
Activity overview
Latest activity by vho
-
How to Find the Client ID
1. To fetch your Foreman API credentials. Those can be found here:
- vho
- Updated
- 1 follower
- 0 comments
- 0 votes
-
How to Replace a Miner After a Control Board Change
Foreman recommends using the replace miner flow so that the linked asset will transfer to the new miner. Here are the steps to do this: 1. On the Miner's table, find the miner and go to Actions bu...
- vho
- Updated
- 1 follower
- 0 comments
- 0 votes
-
Why Would a Whatsminer Unit Run Warm?
Foreman monitors the temperatures of both board and the individual chips on Whatsminer units but Bitmain only reports the board temperatures, which is why they appear hotter than boards.To accommod...
- vho
- Updated
- 1 follower
- 0 comments
- 0 votes
-
How Does Foreman Calculate Power Consumption?
The calculation of power data per machine is derived either directly from the manufacturer or estimated based on the nameplate hashrate and active hashboards when direct data isn't available.For ex...
- vho
- Updated
- 1 follower
- 0 comments
- 1 vote
-
Syncing Assets in the Foreman Dashboard
Syncing assets allows you to connect an asset with an infrastructure component or an asic miner within your fleet. This is beneficial when looking at the lifecycle of a miner or if you want to conf...
- vho
- Updated
- 1 follower
- 0 comments
- 0 votes
-
How to link an Asset with a Miner
1. Foreman has a feature that lets you link assets to a miner, via the use of an Asset ID. This offers considerable flexibility in syncing miners with assets. There a couple ways you can set up the...
- vho
- Updated
- 1 follower
- 0 comments
- 0 votes
-
How to Set an Alert When Your Inventory Item Reaches A Low Threshold Count
1. When the quantity of an item in your inventory falls to or below a specified level, this functionality triggers an alert and automatically dispatches an email notification to you, as configured ...
- vho
- Updated
- 1 follower
- 0 comments
- 0 votes
-
How to Set Up an Alert for Low Fan Speed
1. To set up fan speed control and receive alerts with Foreman for fan errors, you'll need to access your dashboard and adjust the fan speed settings for your miners on the 'Miners' page.Make sure ...
- vho
- Updated
- 1 follower
- 0 comments
- 3 votes