Updated

The Issues page shows every problem Foreman has detected on the miners in your current client, so you can see how healthy your fleet is and jump straight to the miners that need attention. It's for anyone who monitors miners day to day.

Where to find it: click Issues in the left-hand menu.

Page Tour

Miner Status

A chart shows the share of your miners in each status:

Status Meaning
Healthy Reporting normally with no failing or warning issues.
Warning Has at least one issue set to warning.
Danger Has at least one issue set to failing, such as not updating or zero hash rate.
Disabled The miner record is disabled, for example after it was pulled for repair.
Pending Added but not yet reporting.

Click a slice to open the Miners page filtered to the miners in that status.

Miners Needing Attention

Shows miners with at least one issue out of your total miners. Red means at least one miner is failing. Orange means there are warnings but no failures.

Miner Status chart and Miners Needing Attention tile on the Issues page

Issues Table

Column What it shows
Name The issue. Hover over it to see the full description.
Status How many miners are failing or in warning for this issue.
Type System (built in), Custom (created by your team), or Group (an issue group).
Count The total number of miners with this issue.
Show Miners Opens the Miners page filtered to the miners with this issue.

Use Filters above the table to narrow issues by name or type, and Export to download a file listing every miner and which issues it has.

Issues table with Name, Status, Type, Count and Show Miners columns

System Issues

Foreman checks for these automatically using the stats Pickaxe collects.

Issue Raised when
Abnormal Hash Rate The reported hash rate is far outside what the miner can produce, usually a reporting error.
Duplicate MAC Two miner records share the same MAC address, for example from overlapping scans or manual entries.
Fan Speed Too High / Fan Speed Too Low Fan speed is outside the miner's expected range. Clears on its own once the value is back in range.
Hardware Errors Exist An older Antminer indicator for hashboard errors. For modern hardware, a custom issue based on error codes is more reliable.
Hash Rate Too Low Hash rate is below the miner's expected range.
Invalid Pool Configuration The miner's pools don't match your trusted pool settings.
Miner Not Updating (Recent, 1 Day, 2 Days, Forever) No stats have been received for about 5 minutes, 24 hours or 48 hours, or ever. "Forever" usually means a manually added miner that never connected.
Miner Rebooted The miner rebooted.
Missing Fan / Missing Hash Board The miner reports fewer fans or hashboards than expected.
No Pools Configured The miner reports no pools.
No Shares Being Submitted The miner's share count hasn't changed over several check-ins.
Pickaxe Offline The Pickaxe that monitors the miner can't be reached.
Temp Sensor Too High A temperature reading is above the safe range.
Zero Hash Rate The miner is reporting but its hash rate is zero.

You can deactivate a system issue you don't need, for example if a custom issue covers it. Miner Not Updating can't be deactivated, and an issue that a trigger uses can't be deactivated until you remove it from the trigger.

Error Codes

Many miners also report vendor error codes, including Antminer, Whatsminer, Auradine and LuxOS. You'll see them in the Error Codes column on the Miners page and on the Errors tab of a miner's details page. To turn related error codes into one readable issue, such as "Bad Hashboard," create a custom issue.

Related Articles

Last verified: November 19, 2026

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Can't find what you're looking for?

Our support team can help with setup, hardware and billing questions.

Contact Support