How To: Allow IP Report Through Windows Firewall

Updated

If you press a miner's IP Report button during Interactive Miner Add, Interactive Fill or Replace and Pickaxe doesn't pick it up, Windows Firewall on the Pickaxe computer may be blocking the broadcast. Add a firewall rule that allows it through.

Before You Start

  • This applies when Pickaxe runs on Windows.
  • You need administrator rights on the Pickaxe computer.
  • Allowing incoming UDP traffic is a security decision. Check with whoever manages your network, and only do this on a computer on your private mining network.

Steps

  1. Open Control Panel on the Pickaxe computer and go to Windows Defender Firewall.

    Control Panel

    Windows Defender Firewall in Control Panel

  2. Click Advanced settings in the side panel.

    Advanced settings in Windows Defender Firewall

  3. Select Inbound Rules in the left-hand pane, then click New Rule in the Actions pane on the right.

    New Rule under Inbound Rules

  4. Choose Port and click Next.

    Port rule type selected

  5. Choose UDP and All local ports, then click Next.

    UDP and All local ports selected

  6. Choose Allow the connection and click Next.

    Allow the connection selected

  7. Leave all three profiles (Domain, Private, Public) checked and click Next.

    Domain, Private and Public profiles checked

  8. Name the rule, for example "Foreman IP Report", and click Finish.

What You Should See

Press IP Report on a miner during Interactive Miner Add. It should appear in Foreman within a few seconds. If it still doesn't, check that the Pickaxe computer and the miner are on the same network, and contact Support.

Related Articles

Last verified: November 19, 2026

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Can't find what you're looking for?

Our support team can help with setup, hardware and billing questions.

Contact Support